How to Install a Multi-Bike Lifter in Your Garage
By Garage Smart | Published: 2026-10-18
Category: How-to Guides
Learn to install a Multi-Bike Lifter for up to 3 bikes. Step-by-step guide with safety checks and common mistakes to avoid.
Quick answer
Mount the included brackets to ceiling joists, attach the lifting frame with straps, then use the Bluetooth app to test the lift before loading bikes.
Why ceiling joist placement matters
The Multi-Bike Lifter's 100 lb weight capacity and balancing frame work best when the brackets are anchored into solid ceiling joists, not drywall or thin furring strips. A common mistake is centering the lifter in the bay without checking joist spacing, which can lead to uneven load distribution and reduced stability when lifting three bikes.
Installation steps
- Locate and mark ceiling joists: Use a stud finder to mark the center of two parallel joists spaced no more than 48 inches apart. The lifter brackets must be bolted into solid wood or metal joists. If joist spacing exceeds 48 inches, you may need to install a cross-beam before proceeding.
- Mount the brackets: Drill pilot holes and secure the two included brackets to the joists using the provided lag bolts. Use a level to ensure both brackets are at the same height. Check that the bolts are fully seated; loose brackets can cause the frame to tilt under load.
- Attach the lifting frame and straps: Hook the balancing lifting frame onto the brackets. Then thread the six 4-foot straps through the frame and adjust them so they hang evenly. Each strap will later cradle a bike frame. Leave the straps loose initially—you will tighten them after positioning the bikes.
- Connect the Bluetooth control module: Mount the control module near the brackets and pair it with the one-touch lifting app on your phone. Follow the app’s calibration routine to set the upper and lower limits. Test the lift with no load first. If the motor strains or the frame wobbles, recheck bracket alignment before adding bikes.
- Load and adjust the bikes: Place up to three bikes on the straps, balancing the weight evenly. Tighten each strap so the bikes are secure but not compressed. Use the app to lift slowly and watch for any shifting. If one bike swings more than the others, readjust the strap positions on the frame before lifting again.
Product facts
- Multi-Bike Lifter: Balancing lifting frame and 6x 4' straps for bike storage The frame spreads the weight evenly across three bikes, and the six straps let you secure each bike independently, reducing sway during lifting.
Multi-Bike Lifter
